Replace Ink Cartridges – Installing CIS for your HP OfficeJet Pro 7740

Install CIS for HP OfficeJet Pro 7740

With our step by step DIY it is easy to replace ink cartridges in your HP OfficeJet Pro 7740 printer even if you are not a pro. To begin with, before replacing it you should make sure that your cartridge is fully empty. And then, you may find that if there are multiple cartridges, then all do not dry out at the same time. So, check the ink levels before planning for a replacement, in all your cartridges by doing test prints.

Install CIS for HP OfficeJet Pro 7740
Install CIS for HP OfficeJet Pro 7740

When planning for a replacement, you can either choose originals or genuine third-party refills such as the CIS. If at all you have concluded that you are going to use a CIS, then you can make use of the following guidelines.

Get Rid of the Old Cartridge First

Without removing the existing one, there is no way you will be able to install a new CIS for your printer.

  • First, switch on your printer
  • And then, make sure in the paper tray it has a paper
  • There is a cartridge access door
  • This is available on the front side
  • Open it to access the cartridges
  • Once open, you must wait for the auto-calibration to complete
  • After which, you can remove whichever cartridge is empty

When you are planning to do a refill, you must handle your old cartridges very carefully. Try to tape the copper contacts before opting for a refill. This is because, when these contacts face any damage, it is irreversible. Meaning, you will not be able to re-use the cartridge again.

Install CIS for HP OfficeJet Pro 7740

When you get the CIS, make sure you remove any tapes or clips that have been protecting the copper contacts or other parts of the cartridge. This is quite essential for you to reorganize the cartridges for your HP OfficeJet Pro 7740 printer. Once it is free of all these extra fittings, you can confidently jump into the cartridge installation process.

  • Turn on the printer
  • Ensure that you open the cartridge access door fully
  • Wait for the carriage to come to a halt
  • Check for the slots
  • And then, carefully insert the CIS into the respective slots
  • This may sometimes need a gentle push
  • And also, remember that the copper contacts will never face you in the process
  • Do not touch any of the circuits or contacts
  • Any damages may cause issues later on
  • For instance, some common issues that occur after replacements include
    • Ink failure
    • Ink clogs
    • Bad electrical connection
    • Printer doesn’t print black
    • Printer prints only lines

After the successful installation of the CIS, in case you happen to face any one of the above-mentioned issues, then you have definitely made a mistake during the installation process. You may have to redo the entire process for which you can always reach to our website https://www.123-hp-com-ojp7740.com/.

  • Share:

Leave a Comment

sing in to post your comment or sign-up if you dont have any account.

WordPress Appliance - Powered by TurnKey Linux